| astronautix.com | R-5 |
![]() |
| R-5 Cutaway |
The R-5 was the first Soviet missile to be armed with a nuclear warhead, the first for which the new southern facility at Dnepropetrovsk took over full design and production responsibility. The R-5 could deliver a 1425 kg warhead over a range of 1200 km, doubling the performance of the R-2. It was also the end of the road in being the ultimate extrapolation of German V-2 technology. Later missiles of both Yangel and Korolev would use other propellants and engine designs. After reaching a velocity of 3044 m/s at burnout, the missile arced up to a maximum altitude 300 km during a 10.5 minute before impacting in the target area with an accuracy of 6 km in range, 5 km laterally. CEP was 1.4 km.
The R-5 was designed primarily for delivery of a radiological weapon. It seems not to have been deployed, in preference to the nuclear-tipped R-5M.
The R-5 originated as Theme N-1 of the R-3 3000 kg / 3000 km range IRBM project. This proved too big a leap, but the R-3A subscale technology demonstrator was authorised in 1949, before being cancelled in turn in October 1951. As a replacement, an 20 October 1951 MOP decree authorised work to start on the R-5 and R-11. Due to the extensive work already done under Theme N-1, the 6 volume R-5 draft project was completed by Yangel and delivered on 30 November 1951. An official decree was issued in 1952 formally authorising development of the rocket with a 1000 km range specified. The original missile was planned to be equipped with a Pilyugin gyroscopic guidance system and to be built in several versions:
These lateral warheads were evidently deigned for dispersal of radiological liquids over a wide area in the impact zone. Such radiological warheads were used on the R-2 and R-5 prior to the availability of nuclear warheads. Similar weapons were discussed at Los Alamos during World War II when it seemed that the atomic bomb would not be ready in time or not work. In this case radioactive waste could be dispersed over a wide area, effectively providing the fallout effects of a nuclear bomb without the blast and fire effects.
The Generator-S radiological warhead for the R-5 was developed in the early 1950's. In order to handle the warhead OKBT Kirov Factory built the shielded manipulator vehicle Objekt 805, which had a total mass of 72 tonnes. Following a demonstration of 20 May 1954 the system was accepted by the military in 1955.
In parallel with warhead development qualification and stand test of the missiles systems were conducted from December 1951 through February 1952. Ten rockets were built in the initial lot, of which two were used for stand tests. Trials of the two test rockets began in 1953 at Filial NII-2 at Zagorsk. A state decree of 13 February 1953 set forth three phases of state trials tests for the missile itself:
Following completion of the trials the missile was accepted for military service. It seems very limited numbers or no R-5's at all actually entered service. The R-5M version with nuclear warhead was deployed instead. Special variants of the R-5 were used until well into the 1970's for test of equipment, scientific research. These included the R-5A, R-5B, R-5V, and Vertikal.
The R-5 was generally built of Amr3 aluminium-magnesium alloy. The tail section was initially built of steel, later being changed to D16T aluminium alloy. Spetsmash built the mobile launch system, similar to that for the V-2. It took two hours to prepare an R-5 for launch.